Yasui Rotating Jewelry Burnout Furnace 13+

Clean Burnout, Precise Control, Reliable Results

Accurate temperatures ensure a safe burn-out during stone-in-place casting.

The Variable Power Heating System automatically and precisely maintains set temperatures throughout the cycles, (999 Programs, with unlimited Ramps and Holds). This is essential with today’s changing materials that are no longer just injection wax. Today, there is a large range of resins that require different precise temperatures and varying temperature controls to ensure a clean burnout. If the resin is not 100% removed from your investment flask, the unburned residue will contaminate your castings and can eat away at the investment cavities.

Comfortable Work Environment & Eco-Friendly Design

• Yasui’s ecological design minimizes and virtually eliminates noxious smells and fumes associated with antiquated gas and tabletop electric furnaces. The unique After-Burner System that is mounted on top of the RBF 13+, RBF 19, and RBF37+ reaches temperatures above 2000F, which is needed to remove the smoke and smells.
• The Yasui Flask Recall System will automatically bring forward the required flask that is typed into the control panel. Having a narrow door design will significantly reduce heat loss while the furnace door is open. The RBF 37+ uses a foot pedal for opening and closing the furnace door.
• Yasui’s Advanced Insulation System contains the heat associated from burnout cycles and still maintains an exterior surface temperature that is cool to the touch.
• The Yasui RBF Furnaces have a built-in Dewaxing Feature for removing injection wax prior to ramping up the furnace temperatures.

Fume Neutralizing Afterburner

Minimal Heat Loss from Opening the Door

Unlike wide regular wide-doored furnaces, Yasui RBF machines have narrower doors that greatly mitigate heat loss and temperature drop.

Variable Power Heating

One burnout cycle can be programmed in 4 steps. Optimum heating power is automatically calculated and applied corresponding to each temperature zone so that precise temperature control is achieved. Low power is for the beginning steps and higher power is for the ending steps. Such careful control has been developed for preventing flasks from possibly overheat at each step.

Platinum Flask

The RBF13+ can reach temperatures up to 950 centigrade and is ideal for casters who cast both gold & platinum.

Easy-To-Access Control Panel

Various information is obtained from the control panel, such as present step no., present burning out the temperature inside the furnace, etc.

Programmable Timer

The burnout cycle will perfectly proceed by the preset time. For instance, if you plan to start CASTING AT 9:00 AM the next day, flasks would be ready at 9:00 AM by the presetting time today. The maximum preset time is 9 days 23 hours 50 minutes.

Program Memory

Unlimited burnout cycles can be memorized on the controller.

Overheat Protection Device Safety For Stones In Flask

The value of precious stones inside the furnace is beyond comparison with the value of the furnace. RBF13+’s overheat protection device on the front panel can prevent the precious stones safely from overheating. Should the temperature exceed the setting value, the power is immediately shut off.

Measures For Power Failure

On power failure during burnout cycle time under automatic burnout mode, present burnout STEP is memorized. And when power is recovered, the burnout cycle can be automatically restored and started from the step number where power failure occurred.